☯☼☯ SEO and Non-SEO (Science-Education-Omnilogy) Forum ☯☼☯

Non - SEO knowledge => Electronics => Topic started by: rolandbaker on April 19, 2017, 03:54:08 PM

Title: Failsafe. Via Missionplanner or Taranis??
Post by: rolandbaker on April 19, 2017, 03:54:08 PM

Hi.
I have been flying for a few months, but have never set a failsafe on any of my 3 drones.
I am looking at it now and I am a bit confused as to the right hing to do.
Firstly. I want to set my failsafe to RTL for all eventualities.
However, Should I set it up via the failsafe page on MP, or via the Failsafe option on my Taranis using a Custom input, or is it both!!
I have set the failsafe option to Enable always RTL, and the same for low batter at 10.4v.
I have set the failsafe option on the Taranis to no pulses.
Is that correct, or is there more I need to do?  I have left the FS PWM at 975.

I didn't find the right solution from the Internet.
References http://diydrones.com/forum/topics/failsafe-via-missionplanner-or-taranis

Vendor Management Software Video linkspam REMOVED! You -- banned!

Title: Re: Failsafe. Via Missionplanner or Taranis??
Post by: SEO on April 19, 2017, 05:32:41 PM

Welcome to the ban list, spammer! >:(